PHYSICISTS NEEDED, THANK YOU, (10 POINTS)

Answer:

You and the car have inertia. If the car comes to a sudden stop, your body tends to keep moving forward. When the car starts moving again, your body tends to stay at rest. You move forward because the car seat exerts an unbalanced force on your body.

Explanation:

This is due to inertia. When the speeding bus stops suddenly, lower part of the body comes to rest while the upper part of the body tends to maintain uniform motion. Hence, the passenger's are thrown forward.

Answer:

size get smaller maybe there is no object remaining

Answer:

If they are heated the size. will be decreased.

Answer:

107

Explanation:

Answer:

Explanation:

The kinetic energy of an object can be found by using the formula

[tex]k = \frac{1}{2} m {v}^{2} \\ [/tex]

m is the mass

v is the velocity

From the question

m = 75 kg

v = 52 m/s

We have

[tex]k = \frac{1}{2} \times 75 \times {52}^{2} \\ = \frac{1}{2} \times 75 \times 2704 \\ = 75 \times 1352 \\ = 101400[/tex]

We have the final answer as

Hope this helps you

Answer:

c

Explanation:

amembers of the group protocista

Answer:

Ohm’s Law states that current is proportional to voltage; circuits are ohmic if they obey the relation V=IR.

Explanation:

LEARNING OBJECTIVES

Contrast shape of current-voltage plots for ohmic and non-ohmic circuits

Answer:

Table C:

Fan Speed Observations of Position vs. Time Graphs

Low:

The slope is curved and it increases as you go up . The points start off close but they spread out as the time increases.

Medium:

The speed increases quicker than the graph for low speed. The graph is less curved than the one for low speed. Also, the points spread out faster than they did for low speed as the time increases.

High:

The Graph has a smaller curve then the low and medium speed. Also, the points are the furthest apart. The slope is not as spaced out as it was for the rest of the speed graphs.

Explanation:

hope it helps

Variations in the angle of inclination or the mass of the cart could be investigated further to investigate the impact on acceleration and further validate the principles of constant acceleration motion.

Objective: The goal of this lab experiment was to investigate the motion of an item with constant acceleration and to examine its velocity as a function of time.

Materials:

Smooth, inclined plane

Cart or tiny wheeled object

Stopwatches and timers

Measuring tape or meterstick

Procedure:

Set up the inclined plane at a 45-degree angle () to the horizontal surface. Check that the plane is smooth and clear of obstacles.

Place the cart or small wheeled object at the bottom of the inclined plane.

Using a meterstick or measuring tape, determine the height (h) and length (L) of the inclined plane.

Ascertain that the cart is at rest at the starting point, which is located at the bottom of the inclined plane.

As soon as the cart is freed and begins to move, start the stopwatch or timer.

Calculate the time (t) it takes the cart to reach each place along the inclined plane. To ensure reliable data gathering, repeat the experiment numerous times.

Determine the time intervals (Δt) between each position for velocity analysis

Data:

Position (m) Time (s) Time Interval (Δt) (s)

0.0                   0.00           -

0.5                   0.50        0.50

1.0                   0.75        0.25

1.5                    1.10              0.35

2.0                    1.50        0.40

Analysis:

Calculate the average velocity between each position by dividing the position change by the time interval (x/t).

Create a graph that plots average velocity (V_avg) versus time (t).

Results:

A straight line emerges from the graph of average velocity against time, demonstrating that the cart's motion was subject to continuous acceleration along the inclined plane. The slope of the graph reflects the acceleration (a) of the cart.

Conclusion:

The experiment successfully demonstrated motion along an inclined plane with constant acceleration. The graph of average velocity vs time revealed important information about the cart's speed, with a linear relationship suggesting steady acceleration. This experiment emphasizes kinematic principles and the significance of using velocity-time data to understand the motion of objects under constant acceleration.

Hence, variations in the angle of inclination or the mass of the cart could be investigated further to investigate the impact on acceleration and further validate the principles of constant acceleration motion.

To learn more about Acceleration, here:

brainly.com/question/2303856

#SPJ3

Answer:

Can you rewrite that sorry

Explanation:

Answer:

3q

Explanation:

Answer: Measure the initial temperature of the water using the thermometer Poke through a food substance measuring 0.5 grams using the needle with the handle. Turn on fire on the burner. Set the food substance on the needle to fire on the burner. Once the food substance starts to burn, place it under the test tube so the water inside it can absorb heat.

Explanation:

Hope this helps!

Answer:

Below

Explanation:

a) To find the force of friction acting on the mass we can use this formula :

     friction = coefficientoffriction x normal force

First we need to find the normal force of this object :

     Fn = mg

          = (6.0)(9.8)

          = 58.8 N

Now we can find the force of friction acting on the object :

     friction = (0.20)(58.8N)

                 = 11.76 N

                 = 12 N (we round this to 2 sig figs)

b) To find the force needed to accelerate this object at 0.68 m/s^2 use this :

     F = ma

     0.68 = x - 11.76 / 6

     x = 15.84

     x = 16 N

Hope this helps! Best of luck <3

Conociendo la longitud y frecuencia de un péndulo, queremos encontrar la longitud de otro pendulo de tal forma que tenga otra frecuencia.

Veremos que la longitud del nuevo péndulo debe ser 6.25m

Sabemos que un péndulo de 4m de longitud tiene una frecuencia de 5Hz.

La frecuencia de un péndulo está dada por:

[tex]f = \frac{1}{2*\pi} *\frac{g}{l}[/tex]

Donde g es la aceleración gravitatoria y l es la longitud del péndulo, remplazando los datos que tenemos en esa ecuación obtenemos:

[tex]5 Hz = \frac{1}{2*3.14} *\sqrt{\frac{g}{4m} } \\\\(5Hz*2*3.14)^2*4m = g = 3,943.8 m/s^2[/tex]

Ahora debemos encontra la longitud de tal forma que la frecuencia sea 4Hz, entonces debemos resolver:

[tex]4Hz = \frac{1}{2*3.14} *\sqrt{ \frac{3943.8m/s^2}{l} }\\\\4hz*2*3.14 = \sqrt{ \frac{3943.8m/s^2}{l} }\\\\l =\frac{3943.8m/s^2}{ (4hz*2*3.14)^2} = 6.25m[/tex]

La longitud del nuevo péndulo deve ser 6.25m

Sí quieres aprender más, puedes leer:

https://brainly.com/question/23483504

Answer:

Explanation:

We are not told what angle the pull rope is to any other reference. That could make a huge difference in the result.

If we ASSUME that the rope pulls parallel to the slope

Then , if T is rope tension

                                  F = ma

T - mgsinθ - μmgcosθ = m(0)

                                 T = mg(sinθ + μcosθ)

                                 T = 40(9.8)(sin14 + 0.15cos14)

                                 T = 151.88677... 150 N

If the rope pulls the sled at a positive angle relative to the slope, As one might expect from an adult holding the rope, then the tension will be increased because only the Tension portion parallel to the slope causes motion in that direction, but will be decreased because the Normal force, and therefore the friction force, of the slope on the sled will be decreased.

What ever games your playing it wont work you cant defeat me hahhahha oh I know :O but he can AHHHH :D D: NOOOO IMPOSSIBLE.

Answer:

Physical change.

A snowflake is still considered water whether its liquid or solid.

Answer:

mark me as brainliest !! PHYSICAL CHANGE

Explanation:

A snowflake is composed of ice, which is water in the solid phase. Water is a chemical compound of oxygen and hydrogen atoms.

Answer:

Explanation:

Conservation of momentum

Final momentum is zero

1200(40) + 750v = (1200 + 750)(0)

v = - 1200(40)/750

v = - 64 m/s

The negative sign means the mini car was traveling in the opposite direction of the SUV

Answer:

true

Explanation:

Physical fitness is a personal responsibility so I would say true

Explanation:

Rules

A match consists of the best of three games of 21 points.

The player/pair winning a rally adds a point to its score.

At 20-all, the player/pair which first gains a 2-point lead wins that game.

At 29-all, the side scoring the 30th point wins that game.

The player/pair winning a game serves first in the next game.

A badminton match can be played by two opposing players (singles) or four opposing players (doubles).

A competitive match must be played indoors utilising the official court dimensions.

A point is scored when the shuttlecock lands inside the opponent's court or if a returned shuttlecock hits the net or lands outside of the court the player will lose the point.

At the start of the rally, the server and receiver stand in diagonally opposite service courts.

A legal serve must be hit diagonally over the net and across the court.

A badminton serve must be hit underarm and below the server's waist height with the racquet shaft pointing downwards, the shuttlecock is not allowed to bounce. After a point is won, the players will move to the opposite serving stations for the next point.

The rules do not allow second serves.

During a point a player can return the shuttlecock from inside and outside of the court.

A player is not able to touch the net with any part of their body or racket.

A player must not deliberately distract their opponent.

A player is not able to hit the shuttlecock twice.

A 'let' may be called by the referee if an unforeseen or accidental issue arises.

A game must include two rest periods. These are a 90-second rest after the first game and a 5-minute rest after the second game.

Answer:

B. The force of gravity that acts on the kitten

Explanation:

Answer: B

Explanation:

The other options have nothing to do with the water apart from transporting it.

Answer:

Explanation:

trfbehherebgqerfherbfhyqerwbfvhrbhferhgvr

Explanation:

M.A = load / Effort

efficiency = M.A/V.R X 100

75 = M.A / 4 X 100

75 = 25 X M.A

M.A = 75/25 = 3

M.A = load / effort

3 = 100/E

E = 100/3 = 33.333

A machine whose efficiency is 75% is used to lift a load of 100m. the effort needed to put into the machine is 33.33 meters if the velocity ratio is 4.

Mechanical advantage is defined as a measure of the ratio of output force to input force in a system, It is used to analyze the forces in simple machines like levers and pulleys.

Mechanical advantage = output force(load) /input force (effort)

Simple machines like static pulleys, as well as a movable pulleys, provide a great amount of mechanical advantage.

A machine whose efficiency is 75% is used to lift a load of 100m.calc if it has a velocity ratio of 4.

As we know that the mechanical advantage of a machine is equal to the product of its efficiency and velocity ratio.

mechanical advantage  = velocity ratio   ×Efficiency

       =4 × 0.75

       = 3

The mechanical advantage is 3 , which means the ratio of load to effort is 3

load / effort = 3

100 m/effort =3

effort = 33.33 m

Thus, the effort put into the machine comes out to be 33.33 m.

Learn more about Mechanical advantages, here

https://brainly.com/question/16617083

#SPJ5

12414253

Explanation:

Answer:

D) 19.8 lbs

Explanation:

1kg in household measurement is equal to 35.274 ounces. 35.274*9=317.466 ounces.

1kg is also equal to 2.205 lbs. 9*2.205=19.8416

9 kg is also equal to 9000 grams, but grams are not a part of the household measurement system

a) 9000 grams. b) 9000 ounces. c) 19.8 ounces. d) 19.8 pounds.

This leaves us with 19.8 lbs